DeWalt DC841 Instruções de Operação descarregar pdf (Página 4)

FLOOR MOUNTING DIMENSIONS

Your saw may be mounted to the floor.

Use the diagram at right to assist you in

placing the saw and fastening it to the

floor.

MODEL 3512-01 3512-03

MOTOR:

Horsepower 3 3

Phase 1 3

Voltage 220 208/230/460

Enclosure TEFC TEFC

RPM 3425 3425

Brake Automatic Automatic

Arbor 1 x 2 3/16 1 x 2 3/16

CAPACITIES:

Maximum Out Rip* 34 15/16 34 15/16

Maximum C rosscut* 24 1/4 24 1/4

Maximum Miter @ 45

1" stock*

16" 16"

Maximum Depth of C ut @ 90

3 1/16 3 1/16

Maximum Depth of C ut @ 45

1 1/4 1 1/4

GENERAL:

Table Height 31" 31"

Work Surface 39"w x 29"d 39"w x 29"d

Rear of Frame to Front of Table 37 1/4" 37 1/4"

Front Fence to Rear of Frame 15 1/2" 15 1/2"

Rear of Saw to Front of Arm 40" 40"

* All specifications taken with a 12" diameter blade and all guards

in place.

Unpacking and Attaching the Table Legs

Your Original Radial Arm Saw has been completely assembled, tested and then partially disassembled. The box included in your

shipment contains the following items necessary for assembly of your saw:

Legs 4 Magnetic Starter 1 3/8” Flanged Cap Screws 16 3/8” Hex Nut 16

3/8” Lockwasher 16 Allen Arbor Wrench 1 Flat Arbor Wrench 1

The machine can be lifted with a forklift under the steel saw frame. A sling or chain hoist may be used under the arm ONLY if

placed at the rear of the arm near the column. Attach the legs using the 3/8” hexhead cap screws, lock washers and nuts pro-

vided in the hardware bag. Tighten cap screws securely after the machine has been lowered onto its legs.

Important

All cable lengths have been adjusted during manufacture to allow for proper movement of the arm and rollerhead. However,

you should check the cables to ensure full range of movement. If adjustment is necessary, loosen the 2 cable clamps (1 inside

of arm, 1 at right rear of arm) and adjust the cables so rollerhead is free to travel the total length of the arm with the motor

pivoted in the roller head so the blade is on the right hand side. Also, check to ensure there is enough slack in the cables be-

tween the rear of the arm and the starter enclosure so the arm can be swung to the right a full 90

while the arm is elevated to

its highest position.

1 2 3 4 5 6 7 8 9 ... 27 28

Comentários a estes Manuais

Sem comentários

DeWalt DC841 Instruções de Operação Página 4

Comentários a estes Manuais

Manuais e produtos relacionados com Serras circulares DeWalt DC841