DeWalt DCH213 Manual de Instruções Página 8

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 53
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 7
Ampere Rating
More Not More
Than Than
0 6
6 10
10 12
12 16
Minimum Gauge for Cord Sets
Volts Total Length of Cord in Feet (meters)
120V 25 (7.6) 50 (15.2) 100 (30.5) 150 (45.7)
240V 50 (15.2) 100 (30.5) 200 (61.0) 300 (91.4)
AWG
18 16 16 14
18 16 14 12
16 16 14 12
14 12 NotRecommended
Do not place any object on top of the charger or place the
charger on a soft surface that might block the ventilation
slots and result in excessive internal heat. Place the charger
in a position away from any heat source. The charger is ventilated
through slots in the top and the bottom of the housing.
Do not operate the charger with a damaged cord or plug.
Do not operate the charger if it has received a sharp blow,
been dropped or otherwise damaged in any way. Takeit to an
authorized service center.
Do not disassemble the charger; take it to an authorized
service center when service or repair is required. Incorrect
reassembly may result in a riskof electric shock, electrocution or fire.
Disconnect the charger from the outlet before attempting
any cleaning. This will reduce the risk of electric shock.
Removing the battery pack will not reduce this risk.
NEVER attempt to connect 2 chargers together.
The charger is designed to operate on standard 120V
household electrical power. Do not attempt to use ff on any
other voltage. This does not apply to the vehicular charger.
Chargers
Your tool uses a DE:WALTcharger. Be sure to read all safety instructions
before using your charger. Consult the chart at the end of this manual
for compatibility of chargers and battery packs.
Charging Procedure (Fig. 1)
1. Plug the charger into an appropriate
outlet before inserting the battery FIG.1
pack.
2. Insert the battery pack (G) into
the charger, as shown in Figure 1, G
making sure the pack is fully seated
in charger. The red (charging) light
will blink continuously, indicating that
the charging process has started.
3. The completion of charge will be
indicated by the red light remaining
ON continuously. The pack is fully
charged and may be used at this time or left in the charger.
Indicator Light Operation
_ ACKCHARGING
PACKCHARGED
==HOT/COLDDELAY
PROBLEMPACKORCHARGER
0000000000
PROBLEMPOWERLINEeo ee ee ee ee
Vista de página 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 52 53

Comentários a estes Manuais

Sem comentários