DeWalt DW9116 Manual do Operador descarregar pdf (Página 5)

3.5 CONTROL MODULE

Figure 3: Control Module

POWER ON LIGHT: Illuminates when battery voltage is applied to control module.

RED X-RAY PULSING LIGHT: Blinks after time delay button or remote cable button is pressed to warn

that the XRS-4 is going to pulse. The light stays on continuously while the XRS-4 is pulsing. This is a

failsafe warning light. If the light does not work the X-ray unit will not pulse.

LIQUID CRYSTAL DISPLAY (LCD): Two digit LCD displays selected pulse, time before unit pulses,

software version, and total number of pulses on the unit.

RANGE SWITCH: Used to alternate LCD between tens digit and ones digit.

UNITS SWITCH: Used to change the value of the tens digit or units digit from 0 to 9. The UNITS

SWITCH is also used with the EMERGENCY STOP SWITCH to alter the default pulse setting.

DELAY SWITCH: Initiates delay mode.

EMERGENCY STOP SWITCH: Stops the unit before it begins pulsing or stops the unit in the middle of a

pulse train. This switch can also be pressed with the UNITS SWITCH to alter the default pulse setting

when the XRS-4 is first powered up.

CABLE CONNECTOR: Lemo connector located on the back of the control module beneath the battery

receives the remote cable or imaging system cable. See Rear View Diagram on page 5 for details.

BACK PLATE: Covers the Oscillator board and contains battery terminal connectors.

UNITS SWITCH

DELAY SWITCH

RANGE SWITCH

LCD

X-RAY PULSING LIGHT

KEY

EMERGENCY STOP \

PULSE DEFAULT

POWER ON LIGHT

CABLE CONNECTOR

BACK PLATE

1 2 3 4 5 6 7 8 9 10 ... 14 15

Sem comentários

DeWalt DW9116 Manual do Operador Página 5