DeWalt DW9116 Manual do Operador descarregar pdf (Página 12)

BOARD INSTALLATION

1. Slide counter board back into the top of the Control Module housing just below the screw

receptacles.

2. Push the counter board up so LED goes through the appropriate hole in the control module

housing.

3. Connect the three white and one black connector.

4. Screw the LED cover back on.

5. Put the three cap screws through the oscillator board and then put the ½” offsets on the back of

the screws.

6. Plug the oscillator board back into the counter board and push it in position.

7. Tighten the three screws holding the board in place.

8. Insert the flat head screw in upper left corner of the oscillator board.

9. Attach the two blue wires, one red wire, and green signal line.

10. Reinstall the back plate.

INSTRUCTIONS FOR BATTERY DISPOSAL Follow all federal, state, and local laws for

disposal of nickel-cadmium batteries. Batteries may be returned to Golden Engineering for disposal.

1 2 ... 7 8 9 10 11 12 13 14 15

Sem comentários

DeWalt DW9116 Manual do Operador Página 12